1. According to the product drawings, the product is fixed horizontally on the equipment rack with saddles and straps, leaving some space for the left and right connectors.
2. Take out the installation parts and assemble them. Check if each fastener is fastened, clean the head and the inner wall of the barrel with clean water.3. Use appropriate amount of glycerin or detergent to scrub the end-plate seals carefully, and rub the same at the incline of the inner mouth of the membrane shell, so as to ensure the smooth advance of the plugging.
4. Filtration membrane installation, generally from the water inlet installation; the filter membrane first push in the same direction one by one into the membrane shell, filter membrane sealing first coated with a little lubricant, the water purifying connector according to the average length in the middle of the membrane core, with wood spar on one end of the board, the other end of the board by the push ring and membrane core after the gap, such as clearance Too large, we can use the leather washer to eliminate, and finally the good end plate.
5, after the end plate is good, put the crescent stop clip in the diaphragm housing slot, and use the fastening screw to lock.